Physical Properties of Petroleum Products Marketed in Congo
Main Article Content
Abstract
The use of fuels and combustibles in internal combustion engines requires strict quality standards to ensure operational efficiency and to limit the environmental impact of emissions. This study focuses on the characterization of the physical properties of petroleum products marketed in Congo, with particular attention to parameters that are critical for proper engine functioning and environmental performance. To achieve this objective, a series of laboratory analyses was conducted on petroleum product samples to determine mass density, specific gravity, color, pH, and viscosity. These measurements were obtained using a controlled experimental setup that included a precision balance, test tube, stopwatch, and an aluminum-ball arrangement for viscosity determination. The characterization carried out provides a coherent description of the physical quality of the petroleum products examined and illustrates how essential fuel properties can be systematically monitored through relatively simple but rigorous testing procedures. The study concludes that careful control of these physical parameters is fundamental to ensuring that petroleum products meet the standards required for safe, efficient engine operation and for reducing the potential contribution of inadequate fuel quality to environmental pollution, thereby underscoring the importance of strengthening quality control practices in the fuel supply chain.
Downloads
Article Details

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
References
Berry, U., Ndzessou, W. B., Nkeletela, L. B., Samba, R. E. J., & Poaty, E. (2025). Study of the viscosity of petroleum products using Hoppler’s method. Advances in Materials Physics and Chemistry, 15(6), 91–100. https://doi.org/10.4236/ampc.2025.156006
Berry, U., Ndzessou, W. B., Nkeletela, L. B., Samba, R. E. J., & Poaty, E. M. (2025). Comparative study of the physicochemical properties of petroleum products sold in the Republic of Congo: The case of lubricants. American Journal of Chemical Engineering, 13(4), 83–96. https://doi.org/10.11648/j.ajche.20251304.12
Boudjemaa, B., & Abdelkrim, D. (2015). Production du biodiesel à partir d’une plante spontanée [Mémoire de master, Université Ahmed Draia - Adrar]. https://theses-algerie.com/2447819521652516/memoire-de-master/universite-ahmed-draia---adrar/production-du-biodiesel-%C3%A0-partir-d-une-plante-spontan%C3%A9e
Boust, C., Lebreton, R., & Patrascu, C. (2019, February). Combustibles et carburants pétroliers (ED 989). Institut national de recherche et de sécurité (INRS). http://www.inrs.fr/media.html?refINRS=ED%20989
Guibet, J.-C. (1997, December 10). Caractéristiques des produits pétroliers. Techniques de l’Ingénieur. https://doi.org/10.51257/a-v1-k325
Le Coin Formation d’In Situ. (n.d.). Les huiles hydrauliques [PDF]. https://www.fluidestransmissions.com/multimedia/3567.pdf
Merlin, F.-X. (2008). Unleaded gasoline. In Chemical intervention guide (p. 12).
WinGD. (2025, November 25). Lubricants guideline (DTAA001621, Rev. B). https://wingd.com/media/p0pl2f43/lubricants.pdf




















